Make a Conservatory Table Wooden Deck Cooler

Sep 8th

Wooden deck cooler – Use the boards of 75 centimeters to create the legs. Screw them to the 1.90-meter planks. For this it performs perforations in the plank of 1.90 to 10 centimeters of the beginning. Mark 2 points, each one 2 centimeters from one of the edges. Drill with drill and 3/16 wick for wood. Screw the legs, leaving a space between the thicknesses of the head. Make sure that the screws are properly aligned before screwing them in. Third, continue with the 79.5 centimeter heads. Mark them 2 centimeters from the beginning and the edges. Perforate in the marks and fix the heads to the table legs with the screws.

Wooden Deck Cooler with Stand
Wooden Deck Cooler with Stand

This will give you the basic table wooden deck cooler structure. Place the foot structure as if the table was already built. Fifth, now that you have the base, you can start with the cover. Use the four planks of 2.2 meters in length. Leave a margin of 6 centimeters outside the frame of the table. The middle space of both pairs of planks should be the size of the planters. Sixth, turn the cover over to place the eyebrows that will hold the flowerpots. Take the planks 1.80 meters long; these will be the eyebrows. You must place them under the cover. Screwed in 4 points on the deck planks but leaving a three centimeters eyebrow into the hollow that will be the flowerbeds.

12 Photos Gallery of: Make a Conservatory Table Wooden Deck Cooler

Image of: Wooden Deck Cooler with Stand
Image of: Wooden Deck Cooler Plans
Image of: Wooden Deck Cooler Box
Image of: Wooden Deck Cooler Benefit
Image of: Wooden Deck Cooler and Bench
Image of: Table Wooden Deck Cooler
Image of: Rustic Wooden Deck Cooler
Image of: Recycled Pallet Wooden Deck Cooler
Image of: Diy Wooden Deck Cooler
Image of: Creative Wooden Deck Cooler
Image of: Buy Wooden Deck Cooler
Image of: Build Wooden Deck Cooler
 

Since this eyebrow will support them. It is important to screw in four points as they must support the weight of the coolers. When you finish the cover, screw it onto the base. Eight, your table is almost finished. In the center space, on the eyebrows, place the wooden pieces of 24 x 18 centimeters and the 9 x 24. You must leave enough space (58.5 centimeters approximately) to place the flower pots. Be careful that they fit well. Do not screw the pieces until you have ensured that the measurement is accurate for your planters. Your table wooden deck cooler ready. You only have to fill with imperfections, sand and lacquer. Place the flower pots and fill them with ice and bottles.