The Biggest Mistakes People Make Building A Wood Fence Post Caps
Wood Fence Post Caps – You start the fence by making a hole about 8 feet apart for a 4x4x8-treated pole. This hole should be dug as far as 2 feet with a post whole digger. Most people stop there with cylindrical holes because digging this hole is the heaviest part of the hedge. To make sure the post is well laid, the fence should use a post whole digger at an angle around the entire diameter of this hole to make a ball-shaped anchor at the bottom of the cylinder. The dug hole dug in this way is much safer and stable.
In this article, we will provide information about wood fence post caps. The mistake others make is unaware of the fact that the wood never sticks to the concrete. Drive with concrete work and you will see those using wooden shapes to frame the nail-held concrete and wooden bets. The next day the concrete worker picked up the nails and the wooden shape fell off the concrete. Another problem is the bugs and the water on the ground can deteriorate the wooden pole. To prevent this problem the fence builder must install a black roof tar at the bottom of the two-foot fence posts that enter the ground. This will prevent it from decomposing and allowing the concrete to stick to the post.
12 Photos Gallery of: The Biggest Mistakes People Make Building A Wood Fence Post Caps
After the posts are leveled and set you should let them dry for a full day before nailing on them. If you start wearing it before the concrete is actually set, you will tap the post outside the level. Many people build wood fence post caps with only two rails to put their fence on. To build a safety fence that will last for years, three rails should be used. The top rail should be placed on a fence post lying in a horizontal position. The fence bar should not be installed more than 8 “above this top rail. If so, they tend to spin and turn as they age. The bottom rail should be no more than 8” above the base of the fence for the same reason.